WARNING!

CHECK TO MAKE SURE YOUR RIFLE IS NOT LOADED!

PLACE YOUR RIFLE IN A CRADLE OR BRACE SECURELY WITH SANDBAGS.

THE RIFLE BAR LEVEL

Level your rifle's horizontal axis (left-right stance) by attaching the "Rifle Bar Level" to the scope mount base (or other flat surface on or near the action). Secure by pulling the attached wide rubber band down, around the stock and fastening to the other end of the bar. Loosen the scope mount rings. Adjust the stance of the rifle until the bubble in the bar level is centered.

VERTICAL ALIGNMENT SHAFT

Place the Vertical Alignment Shaft down range 15’ to 30’ ( or whatever distance gives you a good clear picture through your scope). Adjust the thumbscrews until the bubble is centered in the level atop the shaft, This gives you a perfectly vertical point of reference.

View through the scope at the leveled down range target and rotate the scope until the vertical reticle is aligned with the "Vertical Alignment Shaft". Re-tighten the scope ring cap screws. You are finished… it really is that easy!